I built a Visual-Basic program that can control arduino pins.
As You can see in the picture, you can choose with COM port to connect,
And you can send a manual command to Arduino by Serial Port,
You can control pin 13 I/O and pin 6 PWM,
You can do the same to the all other pins.
On the Arduino, he recives all the bits and put them on char until he see the command sign [/].
Then he test bit after bit and do the command.
M = Mode [0 to I/O 2 to PWM, 1 is on work...]
P = Pin [02-13]
S = State, on mode 0 is 1 to on 0 to off, on mode 2 is [001 - 256].
Here's a download for this program: V1 http://www.mediafire.com/?k6rr5a6awk4jk6m
Arduino sketch[sorry if it bad...]:V1 http://www.mediafire.com/?fc90o2tol7hdwuu
In the future i will build system to control servo and more, and the Arduino will can send feedbacks...
Thank you, that is my first post here...