Let's Make Robots!

UNIO memory breakout board

A few weeks back I aquired some memory chips(samples rock). These are the special unio memory chips, essentually 1 wire for both input and output. As this is an 8 pin chip with only 3 of the pins being useful, I decided to try to make a simple breakout board with some small 5x5 hole pcb boards I grabbed from SF. These unio chips can be used with the20x2, 28x2 and 40x2 and the three pins are vcc, vss and I/O. The chip id is 11aa040(4k memory)

As recommended, I've added a small pullup resistor to the board. This is the results of...

And the backside which is always wire madness even for a simple board like this....

So the next part of this is to actually try it and make sure it works.... :D