Let's Make Robots!

Stackable SN754410 Motor Driver Boards, 1 Amp per board, 2 Motors per Stack

 

This board is what everyone needs! It can operate as a single Motor Controller, Or Stack them for increased power! You can stack as many boards as you want on top of each other, and the headers simply connect to each other. Requires 6 Lines (or 4 if you tie the Enable lines high) for control over all sides of the H bridge. This allows High side and Low Side Braking, as well as coast. Every stack of drivers controls 2 motors, and for more amperage just stack the boards on top of each other. Every board can handle one amp independently, and has adequate traces for that power. Since the amperage will be flowing through the doubled up headers, It Should be able to handle up to 12 amps (if every pin header is rated at 3 amps). This means you can control very beefy motors with your surplus 1A SN754410's! This board is available for sale now, shoot me a PM and you will recieve a quote for the price of the board. I plan to have a stock of these available soon, and I hope to have them ready within a couple weeks!

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.

Actually I think that a stackable H-bridge board could be quit handy. 
If you need more current, just slap another one on top and your ready to go. If you need a separate motor controller, solder on a 90 deg header for the control lines but still use the power headers and slap on.
Humm… that is something that I have never seen…

Thank you so much for that link! I have updated the board to utilize the proper thickness traces (40mil) so it can handle the full 4 Amps. Usually what I do Andersen is just layout the board so that all the connections are connected. Then I redo the board, learning from the previous layout and making the traces as thick as they will fit on the 2nd revision.

That sounds like a good approach.
When you do your layout, do you start with a schematic and then do the layout via rats nest so that Eagle can validate the layout, or do you just start routing?
I think this board will get very hot if run under full load. You probably should try to get as much surface area connected to the GND center pins of the SN754410 as possible to disperse the heat.

There is a large ground plane with all of the center gnd pins connected. That should provide some heat sinking. I start with the schematic, finish it then route the board and rats nest along the way.

This is a great idea Krumlink but as usual I have some questions about the trace width. Have you done any calculations on this. 4A is quite a lot of current running through those thin traces.
http://circuitcalculator.com/wordpress/2006/01/31/pcb-trace-width-calculator/