Let's Make Robots!

How To Upload Your First PICAXE Code

Teaches how to upload picaxe code to it's board. ; )

I'm just going to post a quick tutorial on how to upload PICAXE code to the selected PICAXE board you have. This tip is dedicated to David Chetrit, who has had some difficulties uploading code onto his board.

Step 1 : Download the PICAXE USB cable driver from here : http://www.picaxe.com/Software/Drivers/AXE027-USB-Cable-Driver/

You can go to the Download tab on that page and choose one suitable for your OS(Mac, Windows, Linux).

Open up the file and follow the installation process.

Step 2 : Download the AxePad Programming Editor from here : http://www.picaxe.com/Software/PICAXE/AXEpad/

Again, you can go to the Download tab on that page to choose one suitable for your OS(Mac, Windows, Linux).

Open up the file and if there is any, follow the installation process. If there isn't and it opens up the AxePad directly, keep it open for later on.

Step 3 :  Check whether you have your battery pack connected to your PICAXE. Red goes to V and Black goes to G on the board. Voltage should not exceed 6V. Now plug the USB cable into the computer and the other end into the PICAXE board. Is there any notification on your computer like : "New hardware installed"? If there is, read on. Open up your AxePad, Click View on the top, then click options, then a window will open. Select your prefered board, in David's case, a PICAXE 28X1/40X1. Now go to ther next tab in this window which is "Port" Select the port you have plugged your cable into. If you are not sure which, click in "List Serial Ports" Now look for the one your cable is connected to and make sure the port is ready to use. Select the port and click okay.

Step 4 : Ready to write some code? Okay, type : 

do 

high 2

pause 500

low 2

pause 500

loop

Now go get your LED and some female connectors. Connect the longer leg of the LED to pin 2. And the shorter leg to minus or ground.

I HAVE CIRCLED PIN 2 IN RED

Setup everything already? Now, make sure everything is connected, battery pack, cable, everything. Now, take a deep breath and click on Program in the AxePad... 

I'd shake your hand and say CONGRATULATIONZ! if it blinks! But if it does'nt, leave a comment below or contact me on the shoutbox.  ; )

Cheers!

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.

@butterytoast & @111swords It is very hard to solve picaxe programming problems through comments, i suggest you to seek help on the shoutbox.

tried everything but i cant get a response out of the board 

I have a new picaxe 28X2 and I have a serial cable and I cant program it can someone help.

(hardware not  found)

I suggest you uninstall the driver and the AxePad, then retry the whole thing again. Remember to check your batts and make sure your cable is plugged in all the way on your usb end and PICAXE end. Keep in mind, you may want to check your OPTIONS, check the correct serial port your cable is plugged into using "LIST PORTS" and see which one has your cable on it and whether it is ready for use. Also, check whether you have selected your correct board (PICAXE 28 X 2). Hope this helped, cheers!

dedicated to ME! YAY! thanx aaron

Thanks for posting this. It is a common question, and a Tip is really helpful. 

I have posted your tip in my LMR Primer FAQ.

Thanks, IG! Hope it will help a lot of newbie PICAXErs. May update anytime soon with some pictures.

sorry tried to post a pic. but not working