Let's Make Robots!

RPI-1031 breakout PCB

I don't suppose someone could help be with the design for a breakout on this sensor?

http://www.sparkfun.com/datasheets/Sensors/rpi-1031.pdf

Meant to buy the Spark's breakout, but wasn't paying attention.  Don't want to waste it.

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.

Why don't you build your own breakout board based on Sparkfun's one?
http://www.sparkfun.com/products/10621

basile

Doh.

Thank you.  I know enough to be dangerous.  Strangely, not to worried about soldering it.  Just didn't want to dig through the datasheet to lay it out.  I just soldered a dozen of these (LiFePo4 charger chips, about the size of an atom), now that took a few PBRs to finish.

http://ww1.microchip.com/downloads/en/AppNotes/01276a.pdf

 

Thanks again.

Soldering said board will be quite a bit more difficult. That chip doesn't look too friendly to solder, and, its pinout is cooky. :P