Let's Make Robots!

Log

Boards & Boards (to get you bored) -- a log of homebrewed circuits coming to life...

I decided to make a blog to serve as a log for the boards I design and/or produce... well mostly because I can. So here it goes.

NOTE: Older boards at the bottom, newer at the top. So do bottom-up read if you're after a chronological perspective.

 

05 - Practice makes perfect (eventually) OR the h-bridgemania

What did you do with your robot today?

What did YOU do with your robot today?

log. voltage

Hi, in my new robot I am using ATmega644, but I need hepl with log. votage. In AVR Studio I set PB7 out and set log 1, but when I measure voltage between PB7 and GND, multimeter shows 0.8 - 1.1 V. Had anybody same problem? But it is not only PB7.  The 0.8 - 1.1 V are on all ports. When I put atmega in to breadboard everything is OK.

I have connected LCD to PORTB and PB7 is controlled backlight. When PB7=1 then backlight on but when I measure voltage on PB7, multimerer shows 0.8 Volts.