Let's Make Robots!
annoying thing when an object is uploaded the stl viewer appears to orbit the grid instead off panning around an object "see the two files below in the stl viewer. … Read more

mirco servo mount

 push fit servo mount " no screws needed" should be a snug fit. the bearing 

used on the mount is a 623Z of ebay.and should be a tight fit may have to work that part to make in fit tight. the bearing not there in the normal sense of a bearing  just to give a c brackets a smooth surface to turn on. so a piece of copper tube at the right diameter could be used.

 

STL Viewer (beta)

Model:
Rotate: |

parts for a Rostock mini

Looking for a home,

 a complete set of  parts  been printed at .22 layer height and a .35 infill solid enough. more details can be found at  ttp://www.thingiverse.com/thing:32850 

 

Creation of a object vault

 LMR 3D printing  group  is growing and 2015 appears to be our  coming out to the world  and every week there appears to be some object repository site  like thingiverse , 3d hub and so on. So why can’t LMR take its place in the world with an object vault for all things robotics.  With the ability to upload stl. Files on LMR sharing ideas never been easier.

holds an oled display
Does exactly what it is says on the tin". A simple bezel free stand took about three hours print and the only other part required is a m3 x 35mm bolt  " an m2 … Read more

Q

test bed for four wheel drive, and hits everything
    Q is my introduction to four wheel drive rover designed to be used with the picaxe 28x2 shield but any controller with  four motors and four servo's will … Read more
supports bots while not in use
as it says on the tin, this two piece stand with a loo roll for the height. Read more

serial between two picaxe

am having a strange issue  getting the 28x2 to communicate  with a 14m2

the 28x2 Tx code here http://pastebin.com/RtDvA4Sk and the 14m2 Rx code here http://pastebin.com/54KeXDaf

now the 28 Tx works as expected but the 14m2 Rx is not, it appears to go to the subroutine as it shows its recieved the data but in the terminal window no values are displaced. any and all ideas welcomed