Let's Make Robots!
Line following Robot
Using a
Line following Robot. It can runs up to 1m/s. hope fully we can participate in RobotChallenge (http://www.robotchallenge.org/robotchallenge) for this year. Read more
  This Robot is based on home-made Aluminium chassis. The size is 40cm x 30cm x 4cm. This Robot has the following: Read more
This is the first prototype of the Balancing Robot. In this version , I used two sharp sensors to control the motors.this is as first step till the IMU comes from … Read more
The PIC RoboBoard1 is a general controller board that is based on general PIC controllers. It was originally designed with 16F887 but can be used with other (40 … Read more
It is the Same DAGU arm in the prevous posts, but the controller is now different. The controller board is Roboduino … Read more
I made a Simple controller for this arm. The controller is based on the Wilde thumper controller from DAGU. It is Arduino based controller with ATMEGA168. For more … Read more
Line Tracking Robot
Using a
This robot is Simple Line tracking Robot. The plat form used is Mr General from Dagu for details about this platform go to http://letsmakerobots.com/node/11703. … Read more
Robot Arm with Object tracking Sensor. The IR eye is used as an Object detection and tracking sensor. For more details about the eye see: … Read more
This is Robot arm Grip from Dagu. This gripper made from 3mm thick aluminium and comes with 2 servos. The gripper will open in excess of 50mm. The servos provide … Read more