Let's Make Robots!

Confused by Arduino's new R3 motor shield.

I'm new to Arduino and microcontrollers in general. I've had an Uno for about a half of a year. Using the diagram posted by Tom Igoe (link below), I made an H-bridge to allow me to control a stepper motor with my Arduino. I made the mistake of buying an Arduino's R3 motor shield, not realizing that the design was so new. Come to find out there is little to no documentation to be found on it. My problem is that I have no clue (other than mounting the shield) on how to wire in the stepper motor and what changes to make to the sketch which works with my H-bridge.