This is my entry for the Office Gadget Challenge. I based my design on Burn-E from the movie Wall-E.
First design stages of the robot i would like to make.
The base of the robot is a metal project box, in the box there is going to be :
I want to make a ring of light for my robot but when i try to program or just give power to the picaxe 08m2 chip it get's hot, really really hot.
- I just got the picaxe 08 proto board http://www.picaxe.com/Hardware/Project-Boards/PICAXE-08-Proto-Board/
I recently got my STM32F0 discovery board, and now i am struggling to program it.
I am using CoIDE, and when i try to debug (what i think is how to program it) than it can't find the toolchain path.
Does someone know what i'am doing wrong?
How do you program a full continius servo (360 degrees) in a Picaxe 28x1 board?
This is my design for my new project: my ButlerBot
It's going to have a table where it can pick things and pour drinks into a cup or something.
I'am stil working on the last details of the design.
More info soon....
I have again problems with my IR-sensors.
I have two of these http://www.dfrobot.com/index.php?route=product/product&path=36_55&product_id=114 connected to input pin 6 and 7 on my 28x1 picaxe projectboard. And even when there's no program on the microcontroller the sensors think that there's something infront of them, but there isn't.
I'm trying to get the code for my robot right, but it is now working.
This is my robot http://letsmakerobots.com/node/30712
This are the sensors i'm using http://www.dfrobot.com/index.php?route=product/product&path=36_55&product_id=114
The sensors are connect to the digital inputs 6 and 7 from the 28x1 picaxe projectboard.