Let's Make Robots!

Morgan 3D printer adventure!

Thanks to Ossipee and his jedi mind tricks I have started working on another RepRap. My first RepRap was a Rostock which was on the cutting edge at the time and now I'm building another rather immature model. I have Ossipee to thank for the ongoing Rostock adventure as well!

Since the Morgan is so new, documentation is still in a state of flux with quite a few people documenting various virtual and real-world builds. While this is good it also has a way of muddying the already murky RepRap waters...

Project Reprap Rostock Rosblog (Hopefully not ROSFLOP!)

Thought I would start a blog documenting my rostock build. Hopefully this will help some other noobs work out the minutae of a project involving so many disciplines!

Zifduino bootloader programming shield

When I first began working with Arduino I was amazed by the incredible things people were doing with the devices. After a couple of successes with my little UNO R3 I wanted to make some things using  "standalone"  chips. Following some tips from fellow Ardweenies I discovered this: http://arduino.cc/en/Tutorial/ArduinoToBreadboard

My PCB Adventures...

Inspired by Birdmun's adventures in PCB's I decided to try my hand at it. I'm no guru, in fact I'm pretty noobish to this whole thing but I thought I'd share some of the things I've worked out with the help of friendly LMR'ers.

All the equipment I'm using is standard stuff that some folks may already have around:

1. Laser Printer. I had an inkjet which will work using a different method that employs special boards made for UV etching but I             picked up a Brother HL-2240 for $60. It was the cheapest no-frills LP I could find.